About this item

• [Breathing Status Indicator & Air Sensor] The built-in air sensor helps monitor air pressure and alert users when pressure is too low or too high. Unlike other plasma cutters that leave users guessing when something goes wrong, this plasma cutter features a three-color breathing status indicator and fault code display to make machine status easier to check and troubleshooting more convenient.
• [Smart APP Remote Control] The APP control plasma cutter can be remotely controlled from up to 98 ft (30 meters) away via a mobile app, supporting Bluetooth connectivity for quick pairing and stable wireless operation. Easily adjust cutting current, switch modes, save preferred settings, and use remote diagnostics to check operating conditions more conveniently without repeatedly walking back to the plasma cutter. This smart control design improves flexibility and efficiency for garage, workshop, farm, and repair jobs.
• [Powerful Cutting Ability] Cut steel, aluminum, copper, and other conductive metals with 110V/220V dual-voltage flexibility. 50 Amp plasma cutter use advanced IGBT inverter technology helps delivers strong and stable cutting performance. It supports a maximum cutting thickness of up to 3/4”(20 mm), with recommended cutting capacity up to 12mm@35A 110V 50PSI; 20mm@50A 220V 65PSI. Clean, dry compressed air is required for best cutting results. Recommended circuit breaker up to 40A@110V; Up to 30A@220V.
• [Pilot Arc & Rust Removal] Bestarc pilot arc plasma cutter features high-frequency non-touch pilot arc starting, allowing the torch to cut without direct contact with the workpiece. It performs well on rusty, painted, dirty, or rough metal surfaces while helping reduce torch sticking and electrode wear. The rust removal mode helps strip away surface rust, oxidation, paint, and light contaminants, quickly preparing metal surfaces for cleaner cutting, welding, and repair work.
• [Easy Long-Cut Control]: This 110/220V dual voltage plasma cutter machine features 2T/4T modes and adjustable PA/PT control. 2T is ideal for short cuts, while 4T allows continuous cutting without holding the trigger. PA time can be adjusted from 3–15 seconds, with longer PA settings helping maintain the arc on expanded metal, mesh, or interrupted cuts. PT post-flow time is also adjustable from 3–15 seconds to cool the torch, protect consumables, and support longer service life.
• [Ready to Cut in 1 Minute]: The pre-installed air filter and 1/4 NPT quick connector help simplify setup, so you can connect the air line and start cutting under a minute. Recommended air pressure: up to 65 PSI, airflow rate: 250 L/min. This plasma cutter designed to meet ANSI applicable safety standards and built with full safety protection against over-current, over-voltage, overload, and overheating, making it suitable for workshop, garage, farm, and job site use. Note: Air compressor is not included.

Product details